How to Install an Exhaust Gas Temperature (EGT) Sensor

Here to talk about exhaust gas temperature sensors or more commonly referred to as an EGT sensor.

Now we have a 2012 Ram 2500 with the Cummins diesel engine it has the check engine light on and we’ve properly diagnosed that as being a faulty EGT sensor, and we’re going to show you how to replace that a little later on.

Here we have several different examples of EGT sensors. The EGT sensor is responsible for reading the temperature of the exhaust, sending this information back to the ECU, which will then use the information to properly control the exhaust after-treatment system reducing harmful emissions. When an EGT sensor fails and the readings become too high or non-existent, this leads to a compromised after-treatment system, resulting in the following conditions:

  • Clogged diesel particulate filter
  • Improper regeneration of the DPF
  • Over fueling
  • Increased exhaust temperature, which can lead to failure of exhaust components or internal engine components
  • Check engine light
  • Idle only state commonly known as limp mode

Ok, we’re here under the vehicle. We have located our failed EGT sensor. Now before you disconnect that, you’re gonna want to remove the negative terminal of the battery. You always want to do this before performing any type of electrical installation on your vehicle.

Leave a Reply